Wall Anchors for Hanging Systems
Secure, Reliable, and Easy Installation
The Ultimate Guide to Wall Anchors for Hanging Systems
Introduction
Choosing the right wall anchor is essential when installing a picture hanging system.
Weak or incorrect anchors can lead to damaged walls and falling artwork.
That’s why AS Hanging Display Systems exclusively uses Cobra TripleGrip® Anchors—a high-performance solution designed for secure and long-lasting installations.
Click Here to watch our recommended installation guide videos at the end of this Blog.
Why Wall Anchors Matter for Hanging Systems
If you're not securing your hanging system to a wall stud, a reliable wall anchor is crucial.
Without the right anchor, screws may loosen over time, causing your artwork or signage to fall—leading to wall damage and safety hazards.
Fun Fact: Standard plastic anchors hold only 10-20 lbs, while Cobra TripleGrip® can support up to 100 lbs!
Why We Trust Cobra TripleGrip® Anchors
Unlike cheap plastic wall anchors, Cobra TripleGrip® Anchors are engineered for maximum grip and reliability.
Works on Multiple Wall Types – Compatible with drywall, plaster, concrete, brick, and tile.
1. Superior Holding Power:
Expands and grips in multiple directions for increased stability.
2. Built-in Anti-Rotation Wings:
Prevents anchor from spinning during installation.
3. Easy to Install
No advanced tools or DIY experience required.
Perfect for picture hanging systems, signage, and retail displays.
Step-by-Step Installation Guide
Follow these simple steps to install Cobra TripleGrip® Anchors:
1. Mark the Hanging Location
Use a pencil or level to determine where your anchor should go. If installing a hanging track, ensure it is straight and aligned.
2. Drill a Pilot Hole
Use the correct drill bit size based on Cobra’s color-coded system. Drill deep enough to accommodate the full length of the anchor.
3. Insert the Cobra TripleGrip® Anchor
Using a small hammer, gently tap it in the Anchor in the drilled hole until flush with the wall. Ensure anti-rotation wings are engaged.
4. Secure the Screw
Drive the screw into the anchor until snug but not overtightened. If using AS Hanging Display Systems, install the track or hardware now, refer to steps 5 and 6.
5. Install AS Hanging hardware
In this case, using the provided hardware, we install the Click and Connect needed to install a Click Rail Track. Screw in until tighten.
6. Install the Click Rail Track
Push track over installed Connectors with a solid rap of a hand at each Connector. A 'click' sound should be heard when the track is properly attached to the Connectors.
Where to Use Cobra TripleGrip® Anchors
Homeowners:
Hanging art, mirrors, shelves, or floating décor.
Businesses
Installing signage, branding materials, or gallery displays.
Art Galleries & Museums
Securing rotating artwork displays without wall damage.
Upgrade Your Hanging System with Cobra TripleGrip®
Say goodbye to weak anchors—get superior grip and strength!
Perfect for AS Hanging’s professional tracks & display systems.
Effortless installation with long-term durability.
Installation Videos
Watch Cobra TripleGrip® Installation Video
Watch Click Rail Track Installation Video