AS Hanging Systems Home

Top Clamp, Small

Top Clamp, Small

Designed from the ground up to present glass panels by grasping the top edge of the panel via a through-hole. However, Top Clamps are not limited to glass panels as all sorts of materials may be professionally presented in the same manner.

A cable, supported above by a pier or track, is brought down to the desired upper edge of a panel and inserted into the cable hole at the top of the Top Clamp. Two supplied set-screws are then tightened against the cable.

Next, a panel or glass lite is brought to the clamp side of the Top Clamp. The clamp is equipped with a set-screw that must pass through the panel. Two bushings are supplied if glass is being suspended and to protect the glass from the metallic screw. The design of this fitting is optimized for suspending glass in a vertical orientation.

It is also possible to connect another pair of Top Clamps to a second set of holes on the bottom edge of a display panel. Cables from these lower clamps can then continue to a lower fixed point and hold the entire assembly in tension. This would be accomplished by use of Fixed Piers or Ceiling Track and Cable Tensioners. The Ceiling Track would be inverted to be used in a lower position. In this way a room divider could be fashioned quite easily. Both sides of the panels could be finished and display material could be equally effective on both surfaces. Likewise, there could be a second panel below the upper one and both could be held in tension from a pair of cables. See Application Guide below.

We offer Top Clamps in small, medium and large sizes. This small size is compatible with monolithic glass sheet of 5/32” (4 mm) and 3/16” (5 mm) thick glass. The same would be true where you would use the supplied bushings to protect the panel of some other easy to chip substrate. When bushings are not required, this Top Clamp is compatible with panels of most any substrate up to 9/32" (7.15 mm) thick. See downloadable documents below, for more compatibility dimensions.

All supplied screws are made of stainless steel for years of service with no maintenance issues.

Panel Compatibility

Glass Panels (use supplied bushings*). See Compatibility Guide for panel thicknesses.
Minimum: 5/32 in. / 4 mm
Maximum: 3/16 in. / 5 mm

Non-glass Panels (without bushings). See Compatibility Guide for panel thicknesses.
Maximum: 9/32 in. / 7.15 mm

Through-Hole Diameter and Placement. See Design Bulletin for reference dimensions.
w/Bushing: 3/8 in. / 9.5 mm
w/o Bushing: 3/16 in. / 4.8 mm

*Bushing must be used with any glass panels. Bushings may be used with other panel substrates where it is desired to avoid the metallic screw from contacting the panel.

Specifications

Rated Strength
150 lbs (68 Kg)

The design of this product is  

VIEW TOP CLAMP INSTALLATION GUIDE (ONLINE):
Top Clamps Installation Guide.

Learn more about this product on our blog

Tensioned Cable System sku:H3045 AS Hanging Systems 5.3000

Popular compatible products

McAfee SECURE sites help keep you safe from identity theft, credit card fraud, spyware, spam, viruses and online scams
PayPal Acceptance Mark
©right;